Procedury

1. Vyber Place Section z menu SEC TOOLS.
   
   Pro/ENGINEER bude napovidat jmena existujicich souboru. Napsat vybrane jmeno souboru nebo listovani pomoci [?]. Jakmile je jmeno vybrano skica se nacte a zobrazi na obrazovce.

   ---

2. Jestlize je skica umistena ve sketcovaci rovine (i.e., ne na pomocne skice,tak jako pro kresleni blind diry nebo shaft)tak je mozna zmena umisteni, orientace a meritka skici.

   ---

3. Zadani uhlu rotace pro skicovani. Je jasne, ze toto zobrazeni kot smi byt zmeneno, protoze byla zmenena orientace skicovani. Enter a rotation angle for the sketch. Be aware that some dimensioning schemes may change because of the change of sketch orientation.

   ---

4. Select an origin point on the sketch for scaling. When scaling the section using the mouse, this origin point will remain stationary.

   ---

5. Select a drag point on the sketch. This is the point that will follow the mouse during positioning.
   
   Note: The drag point cannot be coincident with the origin point for sketch scaling.

   ---

6. Enter a preliminary scale factor for the sketch. (The default value is 1.000).

   ---

7. Now the section can be placed on the part. Move the mouse from the sub-window to the part window. The section will appear in red and will follow the mouse as it is moved around the screen.

   ---

8. Options while using the mouse are:
   
   
   • Click the left button to place the section. It will then turn to section color and any dimensions will appear.

   • Click the middle button to abort the section placement and return to step 3 .

   • Click the right button to toggle back and forth between scaling and drag modes. When scaling, the scale origin will remain stationary, and moving the mouse will increase/decrease the size of the section. Returning to drag mode will cause the drag origin to once again follow the mouse.

   ---

9. Locate the section with respect to the part by dimensioning or aligning.

   ---

10. Regenerate the section.

    ---